Who Is Responsible For An Peugeot 308 Key Fob Budget? 12 Ways To Spend Your Money

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be somewhat old-fashioned, but it is still attractive. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is persistent or intermittent the following suggestions should assist.

Water Damage

When you accidentally leave your fob in the midst of a puddle or splash it with water during kayaking, swimming, canoeing, rafting or canyoning, it's more likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in activities that expose it to large amounts of water.

You should also make sure that the fob is completely dry prior to opening it and reusing it. If you smell any odors emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indication that it's submerged.

A wet circuit board can cause the battery to lose its charge or even explode. If you're able, if you can, pull your key fob 308 out of whatever body of water it was stuck in, flip the button side down and shake it out as much water as you can before opening the case. Remove the battery, then clean the circuit board with a cotton swab that is dipped in 90 percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not work include a dead coin-cell battery, receiver module problems signal interference, or a malfunctioning chip. If none of these are the cause, you can try resetting the system by disconnecting the battery that is 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely helpful, especially during winter's cold and chilly months. However, it is possible that the remote start system ceases working due to a variety of reasons, like an unresponsive coin battery.

The coin-shaped battery that is inside the key fob can last between two and four years based on how often it's used, the location it was purchased and how it is utilized. The date of use will be printed on the package or mentioned in the user's manual.

If the key fob has stopped working after exposure to water that is clean it is recommended to remove the battery, then clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it completely before replacing it. In the event of exposure to soapy or salty water, the chip might be fried and you will need to replace the key fob altogether.

If you are not sure the battery is in good condition, you can test the voltage with an instrument set to the vehicle's voltage range and connected to the minus and plus terminals. If the voltage is lower than 12-13 volts you should replace the battery. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, it's possible that the receiver module has developed a fault. It's the component that sends an alarm to the car when your key fob is activated, which also acts as an immobiliser. It also stops it from starting unless the correct key is present.

This could be due to a range of reasons, including water damage or simply the aging process. If your Peugeot 308 key fob has been exposed to dirty tap water, like the electronic chip inside may be damaged. In this instance, you'll have to remove it and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try again.

If the issue isn't resolved, it's probably a good idea to see a local Peugeot specialist or locksmith. They'll be able to use a diagnostic tool to identify the problem and fix it.

It can be a stressful experience to lose your Peugeot car key. However, a reputable auto locksmith can fix the issue in just a few minutes. They can cut a brand new key and program it to your vehicle, ensuring you're ready to get off the road in the shortest time possible. Find locksmiths near you.

A malfunctioning electronic chip

The electronic chip in the Peugeot 308 key fob plays a vital function in the remote control system. If it gets damaged, your car might not start or you might receive a message stating "anti-theft active". If this occurs, the only solution to fix the issue is to obtain a new key. Fortunately, auto locksmiths with experience are able to provide this service in the shortest time.

peugeot key replacement  inside your Peugeot 308's key fob may fail due to a variety of reasons, such as sweat, water damage or dirt. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to clean it immediately. You can make use of a towel and isopropyl alcohol to wipe the electronic component. After that, let the battery dry completely.

Sometimes, a key fob can not function due to radio interference. This can be caused by other devices that operate on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity. If you experience this issue you should visit a Peugeot dealership.

The Peugeot Key Fob 207/308 is delicate and needs particular care. It is essential not to drop or throw the key fob. If you lose it, try to find it as soon as you can. You can reset all on-board computers by disconnecting the battery that is 12 volts for a short period of time. Remove the negative cable before the positive.